Then Target Weld (press the 'W'
key) point "1" and point "2" to to the point highlighted in blue.
Note! To target weld a point or an edge, you press the
'W' key and then click the point or edge you wish to weld. Then move the
cursor to the point or edge you want to weld it to and click it. A red line
will follow the cursor when the tool is active.
Target weld this "floating point" (red arrow points to
it) under her left arm to the point circled in red.
Now I'm going to make the
straps that will cross at her right hip and join to the skirt.
Edge extrude the selected
edge several times, following the curve of her lower back until you get to her
right hip.
Rotate the edge as you go
so that it lays like an actual cloth would.
Do the same with the bottom edge closest
to her right side in the front. When they cross, be sure neither strap pokes
through the other.
Select these two edges and bridge them
with the bridge tool.
Here is an example of "poke-through" that
needs to be fixed.
Same as I did with the armband, I'm going
to edge extrude a waist band that will connect with the strap in the back.
When you near the middle of her back,
start extruding edges from the other side until they are close enough to use
the bridge tool to connect them.
