|
 |
|
Using the Y-axis translate
tool on the gizmo (green arrow), move the selected edge-loop up as shown. |
 |
|
Grab the middle edge-loop
and move it up to the center of the chest. |
 |
|
Scale the edge-loop in the z-axis using
the small blue square on the gizmo until the front of the dress covers the
breasts. |
 |
|
Select different edges and start moving
them into place around the model to make a tight fit for the top of the
dress. Select individual points as well using the Point Tool to make
finer adjustments. |
 |
|
When you get tired of doing that, select
this edge above the right breast. We want to make a "Ring" selection
where all the parallel edges are selected. To do this, click the "Ring" icon
next to the "Loop" icon.
Note! Here is another tool you should
map to the keyboard shortcuts. You will be using it a lot. :) |
 |
|
What you end up with is this. |
 |
|
Press the 'X' key to cut the edges in
half and create a new intersecting edge-loop. The 'X' key is a shortcut key
for the Tessellation Tool. |
|
 |
|
Select the new edge-loop and
move it up to the shoulders. |
 |
|
Next, select the top
edge-loop and position it around the base of the neck. This is going to
become the base of a collar/choker. |